MOD64 Panel |
  
|
MOD64 Panel |
|
Below, we have the information panel for the MOD64.
At the left side of the panel we can see the device status information followed by alarm indications and, below it, the state of two internal cyclic timers, showing if they are ON or OFF and the amount of time the timer is in the current cycle (mm:ss).
Beside the items above mentioned (located in the center of the panel) we can see the display images for the two sensors connected at the MOD64 analog inputs. The display can also indicate the device status: when the display shows “N/R” it is indicating that the respective device is not responding. You can see that device status indicates Failed or Off. If device status indicates “Maintenance”, the display exhibits only “- - -”.
Below the display images you can see two different set of data; digital/analog input data and output data.
For each input a field informs the amount of time an input signal is present (when the hour meter is enabled); a LED indicates whether the input signal is present or not. The input name configured in the device setup is also displayed.
For each output a button is available to turn it ON or OFF manually (if an “A” appears in the button, then the output is in automatic mode, linked to an internal control in the device). An LED indicates if the output is ON or OFF. And the output name configured in the device setup is also displayed.
At the right side of the panel we have the model name and, below it, an area available for your company logo.
At the left lower corner of the panel you can find the Rules button (below the timers). It allows you to configure the device rules and validation. The Setup button allows you to access the device configuration options.
See Also
URL of this page