Painel of the PCT-400Ri plus |
  
|
Painel of the PCT-400Ri plus |
|
Below, we have the information panel for the PCT-400Ri plus.
As we can see, in the upper left hand corner of the panel are in the indication of the operating mode for the instrument.
Below the indication of the operating mode, we find the information referring to the alarms for the instrument. If any of them are activated, the indication light on the side of the alarm will turn yellow.
Beside of the indications cited above, is the representation of the instrument's display. It shows the pressure of the sensor. The display may also indicate the status of the instrument, when the display shows "N/R", it will be indicating that the instrument in question is not responding. You may observe that the status of the instrument will be indicated "Failure" or "Disconnected". If the status of the instrument indicates "Maintenance", the display will simply show "- - -".
Below the representation of the display, we can see the indication of the remote alarm, and further, the setpoint of the pressure and the control differential (hysteresis).
Beside of the representation of the display, we have the description of the type of pressure gauge (Suction or Discharge). Below the description, we have the indicators of the state of the instrument outputs: OUT1, OUT2, OUT3, OUT4. When a red light appears in the space corresponding to the output, this will indicate that it is on. Finally, below the outputs, there is an indication of the percentage of the demand for the activation of the stages.
Also on the panel, you find the button Setup to access the setup of the instrument. It will be necessary to provide the access code for this purpose.
When the instrument highlighted is associated to another, there will be a button on the panel to select the other instrument for association.
See Also
URL of this page