Panel of MT-512Ri LOG |
  
|
Panel of MT-512Ri LOG |
|
This is the info panel for the model MT-512Ri LOG:
The upper left corner shows the device status and its internal clock date and time.
The device alarm data can be seen below the device clock display. When the alarm is ON the corresponding indicator LED at left appears yellow.
In the lower left corner the settings configured for Setpoint and Hysteresis can be verified.
The device digital display is shown at the right hand side of the previous Alarm display. The upper value shows the sensor temperature and the lower value shows the timer for the current operation. The digital display also shows “N/R” when the corresponding device is Not Responding. In this case the device status shows “Failure” or “Disconnected”. The digital display also shows “- - -“ when the device status is “Maintenance”.
At the right hand side of the previous digital display the output LEDs indicate the status for the cooling output (REFRIG) and the defrosting output (DEFROST). An output LED appears red when the corresponding output is ON.
Below the Output display we can find the section for the internal datalogger. The amount (%) of internal memory used is shown (only when the memory is not configured for the Data Shift mode). The indicator LED shows the datalogger monitoring status and a button allows the user to enable/disable it. There is also a button to load the data stored by the datalogger and another button to clean the memory.
The upper right corner displays the model name and the upper lower corner is a free space where you can display your Company logo.
At the lower center part of the panel the Setup and Invert Status buttons allow you to access the device functions and reverse the device status by switching the operation mode between cooling and defrosting. An access code is required.
See Also
URL of this page